★ Pebble Tec Certified Applicators Free On-Site Estimates Residential & Commercial
Mon–Fri 8–6 · Sat 8–2 · (619) 514-1271
San Diego, CA · Swimming Pool Repair

Pool Repair in San Diego

Leaks, cracks, hollow spots, failing equipment or a rough plaster surface? OceanView diagnoses and repairs residential and commercial pools across San Diego County — and tells you honestly when a repair will do and when it's time to resurface.

✔ Leak Detection ✔ Equipment & Plumbing ✔ Surface & Structural Repair
Swimming Pool Repair

Fix the problem before it costs you a whole pool

Most pool problems start small — a hairline crack, a slightly rough patch, water that seems to drop a little faster than it should. Left alone in San Diego's sun and salt-tinged coastal air, those small issues turn into big ones: a leak that undermines the deck, a hollow spot that spreads across a wall, or a plaster surface so far gone that the only fix is a full resurface. OceanView Pool Resurfacing repairs the whole pool — surface, structure, plumbing and equipment — so a minor issue stays minor.

We're expert-certified in pool plastering and Pebble Tec application, which means we understand exactly how a pool shell and its finish are built. That matters for repair work, because a lasting fix depends on treating the cause, not just patching the symptom. Every repair starts with a free on-site diagnosis and a written recommendation — no guessing, no upselling you into work you don't need.

Pool repairs we handle

Leak detection

Losing water faster than evaporation explains? We track leaks down with a bucket test, dye testing and electronic leak detection rather than tearing up your deck on a hunch. Leaks commonly hide at the skimmer, return lines, main drain, light niches and plumbing fittings. Once we've pinpointed the source, we repair it and confirm the pool holds water.

Plumbing repair

Cracked or blocked suction and return lines, leaking valves, failing skimmers and corroded fittings all rob a pool of proper circulation. We repair and re-plumb the lines that keep your water moving and filtered so your equipment isn't fighting a losing battle.

Pump, filter & equipment repair

A pool is only as healthy as its circulation. We service and replace pumps, filters and valves, diagnose equipment that won't prime or hold pressure, and get the system running efficiently again. Failing equipment doesn't just cost you clean water — it drives up energy use and shortens the life of your finish.

Cracks & hollow spots

Structural cracks and hollow spots — areas where the plaster has debonded from the shell — are among the most common calls we get. We chip out the failed material, address what caused it, and re-bond a fresh patch so it doesn't come back. Catching these early is the difference between a targeted repair and a much larger job.

Surface & plaster spot repair

Rough patches, chipped plaster, pop-offs and stains can often be spot-repaired when the rest of the surface is still sound. We match the repair to the existing finish as closely as possible and blend it in. When plaster spot repair alone won't cut it, our pool replastering service gives the whole interior a clean, uniform new coat.

Repair or resurface? How to decide

The most valuable thing we do on a repair call is give you an honest answer to one question: is this a repair, or is it time to resurface? A single crack, one hollow spot, or a localized rough patch is a repair. But when staining, roughness, exposed aggregate and multiple hollow spots show up across the whole pool, the finish has reached the end of its life — and patching it repeatedly costs more than doing it once. In that case, pool resurfacing in San Diego delivers a smooth, sealed, uniform surface that lasts years, not months. If you're seeing several warning signs at once, our guide to the signs your pool needs resurfacing walks through exactly what to look for.

For pools that have been neglected, drained too long, or left green over a wet season, repair and resurfacing often go hand-in-hand as part of a broader pool restoration — bringing the surface, tile, equipment and water all back to service together.

Our repair process

1

On-Site Diagnosis

We inspect the surface, shell, plumbing and equipment, run leak tests if needed, and identify the real cause — then quote it in writing.

2

Prep the Repair Area

We chip out failed plaster, open up hollow spots or cracks, and clean the area so a new patch or seal actually bonds.

3

Make the Repair

We seal leaks, re-plumb or replace equipment, and re-bond and finish surface repairs to match the existing pool as closely as possible.

4

Test & Verify

We confirm the pool holds water, circulates properly and the repair is sound before we consider the job done.

Cost factors for pool repair

Repair pricing depends on what's actually wrong, so we never quote blind. A minor plaster patch or a single hollow-spot repair sits at the low end. Leak detection and repair costs more when the leak is buried in plumbing rather than at an accessible fitting. Equipment repairs vary with the part — a valve or seal is modest, a full pump or filter replacement is more. Structural crack repair depends on length, depth and cause. The one constant: on a free on-site estimate we give you a firm written number, and we'll always flag when spending on repairs is money better put toward a resurface.

Serving San Diego County

We repair pools throughout the region, from the historic, older pools of Mission Hills and the coastal properties of La Jolla to newer builds in Chula Vista and the inland pools of El Cajon. Wherever your pool is in the county, the same certified crew shows up to diagnose it and fix it right.

Questions

Pool repair FAQ

How do I know if my pool is leaking or just losing water to evaporation?

San Diego pools naturally lose a little water to evaporation, especially in summer. A simple bucket test — comparing the drop inside a water-filled bucket to the drop in the pool over 24 to 48 hours — tells you whether the loss is normal evaporation or a leak. If the pool drops noticeably faster, we run electronic leak detection and dye testing to pinpoint the source before any repair.

Can you repair a crack without resurfacing the whole pool?

Often, yes. Isolated cracks, hollow spots and small plaster failures can be repaired without a full resurface. We chip out the damaged area, address the cause, and patch it. When the surface is broadly worn, stained or delaminating across the pool, spot repairs stop being cost-effective and a full resurface is the better value.

What is a hollow spot and is it serious?

A hollow spot is an area where the plaster has debonded from the shell beneath it — you can often hear a hollow tap when you sound it. Small hollow spots are common and repairable, but left alone they can spread, crack and let water reach the shell. We repair them by removing the loose plaster and re-bonding a fresh patch.

Do you repair pool pumps, filters and other equipment?

Yes. Along with surface and structural repairs we service and replace pumps, filters, valves and related plumbing. If your pool won't hold pressure, won't circulate, or the equipment is failing, we diagnose it on-site and give you a written repair recommendation.

Should I repair my pool or resurface it?

It depends on how much of the surface is failing. A single crack or one rough patch is a repair. Widespread staining, roughness, exposed aggregate and multiple hollow spots usually mean the finish has reached the end of its life, and resurfacing gives a better long-term result. On a free on-site estimate we tell you honestly which one your pool needs.

What areas do you serve for pool repair?

We handle pool repair across San Diego and the surrounding county, including Mission Hills, La Jolla, Carlsbad, Chula Vista, El Cajon, Poway and Santee, for both residential and commercial pools.

Ready When You Are

Get your pool problem diagnosed

Free on-site estimate, honest advice, and a lasting repair. Call now or request your quote online — we'll tell you whether it's a repair or a resurface.

📞 Call Now Free Quote